INSTALL INSTRUCTIONS

Items Needed:
   * #14 x 3" flat head Phillips wood screws - 24 per lane
   * Impact driver or screw gun
   * Phillips bit
   * 11/16" spade bit
   * 3/16" drill bit
   * Adjustable wrench

Terms:
   * Front: Towards foul line
   * Rear: Towards rear of machine

Hints:
   * Drill all new holes and use new screws
   * For best results, rip the flat gutters down the middle with a table saw

Instructions:
   1. Turn off power to pinsetter.
   2. Remove all screws from flat gutter and remove flat gutter.
   3. Clean all debris from the concrete surface between middle and rear flat gutter supports.
   4. Inspect the middle and rear flat gutter supports. You want them to be as tight as possible. If they are loose, you will need to "tie" them to the 2 x 10 supports beneath them both on the pin decks and kick back side using good quality wood screws. The tighter these supports, the better the overall results will be.
   5. Remove the WAHSAM from the box. You will see 2 jam nuts. Loosen the bottom jam nut. The top jam nut nearest the 3 tubes always stays tight. The adjustment comes from the bottom jam nut.
   6. Place the WAHSAM on the concrete floor between the middle and rear flat gutter supports. The best location is in line with the 4-5-6 pins spots or slightly to the rear.
   7. Place your level so it is resting on the top of the middle flat gutter support and on top of the WAHSAM.
   8. Adjust the height of the WAHSAM by spinning the head so that a 1/4" gap is obtained at the rear flat gutter support. Refer to the video if need be.
   9. Tighten the jam nut when proper height is achieved.
  10. Re-install the flat gutter. If the existing screws were in good quality and tight, you can reuse them. If not, use new screws. #14 x 3" usually work the best.
  11. Tighten all screws securely making sure that the bottom of the flat gutter is resting tightly against the middle and rear flat gutter supports. - VERY IMPORTANT!!
  12. For best results, install 2 new woods screws in line with existing screws at the rear and middle support.
  13. Double check all screws for tightness.
  14. Inspect by dropping pins as per video, being careful not to get hit by flying pins.